Mr2 manual transaxles

Remove the intercooler, and underneath is a 24mm bolt that goes straight to the transmission. There is a similar, smaller bolt on the C-series transaxles next to the transmission vent. Make sure you out the correct amount in, remembering you probably didn't get it all out in the first place -- around 3. Tags:Array The grinding noises associated with hard shifting due to syncro wear may be reduced a little by changing the transmission oil.

Toyota MR2 Repair Manual. Toyota MR2 Wiring Diagram. This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish.

Next, use the 24mm socket paired with the breaker bar to loosen the fill port plug make sure to open the fill port first. Once the fill plug is removed, use the socket to loosen the drain plug. Both plugs are accessible without needing to jack the vehicle. Before removing the drain plug, place a drain pain underneath the drain port to capture the old transmission fluid.

Once the old transmission fluid has drained out, install the drain plug with crush washer and torque to 37Nm 27ft-lbf. Next, use the fluid pump to fill the transmission with fresh fluid. Fill the transmission until fluid starts running out of the fill port. Except where otherwise noted, site content is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.

The 5SFE 2. The 3SGE 2. The 3SGTE 2.